Knees included with kit

The place to discuss SCAMP (Small Craft Advisor Magazine Project), our 11' 11" micro minicruiser.

Moderator: Moderator

Post Reply
Stacy Smith
New Contributor
Posts: 9
Joined: Wed Jul 06, 2011 3:06 pm

Knees included with kit

Post by Stacy Smith »

Good evening. Can someone direct me to a picture of the correct installation of the knees that are included in the kit? They appear to be for the stern, either under the combing or the cap. The angle and bevel is about the same. I'm thinking under the combing, but don't see them in the instruction booklet or plan sheets. The longer side has a square end and the other side a curve. Tried a word search but no luck yet. Thanks for any assistance,

Stacy Smith
Rudderville, TN
mrogers
Major Contributor
Posts: 208
Joined: Tue Sep 11, 2012 8:43 pm

Re: Knees included with kit

Post by mrogers »

Could be the mast trunk sides. Can you give us a picture?
Roger-Scamp177
The pleasure I get from a boat is inversely proportional to it's size cost and complexity
Stacy Smith
New Contributor
Posts: 9
Joined: Wed Jul 06, 2011 3:06 pm

Re: Knees included with kit

Post by Stacy Smith »

Resolved. picture removed
Last edited by Stacy Smith on Fri Sep 05, 2014 8:23 pm, edited 1 time in total.
Stacy Smith
New Contributor
Posts: 9
Joined: Wed Jul 06, 2011 3:06 pm

Re: Knees included with kit

Post by Stacy Smith »

Okay, I figured it out looking at the nesting diagram. They are the cabin side doublers, which go at the front of the cabin. You know, it's amazing how many parts of this boat have the same angle. Thanks!
Post Reply